Table of Contents
Advertisement
Always use the correct supply voltage: The
power supply voltage must match the informa-
tion quoted on the tool identification plate.
INITIAL OPERATION
Functional test for the GFCI protective
switch 4
WARNING: The ON/OFF switch 2
must be switched off, in order to
avoid unintentional starting of the
machine when carrying out the
functional test of the GFCI protec-
tive switch 4.
Before commencing work, check that the GFCI
protective switch is functioning properly:
•
Press the «ON» button on the GFCI protective
switch. The red control lamp indicates when
the protective switch is ready for operation.
•
Press the «TEST» button. The control lamp
must go off.
Setting the speed range
CAUTION: Actuate the gear selector
switch only when the machine is at
a standstill.
The gear selector switch allows for pre-selection
of three speed ranges.
Position •:
low speed
Position ••:
medium speed
Position •••:
high speed
Switching On/Off
Switching on:
Press the ON/OFF switch 2
(position "1").
Switching off:
Press the ON/OFF switch 2
(position "0").
WARNING: Use BCR130/5 only in
combination with a drillstand when
drilling in first gear, Position 1 (low
speed).
10
BEAST CORE RIG OPERATING MANUAL
®
BCR130/5-BCR164/6,5-BCR300/12
Overload Protection
The LED 1 indicates the motor load, whereby the
following conditions are distinguished:
Blue:
No load
Green:
Regular drilling load
Red:
Overload
Excessive overloading will shut down the motor.
After the motor has cooled off, the motor can be
switch on again with the Overload Safety Switch
47.
Connecting the water feed
•
Close the water tap 7.
•
Connect the water feed hose to the water tap
or the water pressure tank.
•
When using the water pressure tank, make
sure that there is sufficient pressure when
working.
•
Check the waterflow indicator 3.
Mounting the drill bit 31
•
Clean and grease the thread on the drill bit
31 and the tool holding fixture 6.
•
Screw a core bit 31 onto the tool holder 6
and tighten.
Removing the drilling core
•
Break off the drilling core and remove.
HAND HELD DRILLING
WARNING: Hand held drilling only
for BCR130/5. Maximum bit diame-
ters:
•
Wet drilling in concrete: Ø 40 mm.
•
Dry drilling in masonry: Ø 164 mm.
Hand held wet drilling
•
For wet drilling open the water valve 7 and
switch on the machine 2.
•
Hold the machine as rigidly as possible.
•
Always use the grip 5 at the front of the
machine.
•
Start drilling by keeping the machine at a
slight angle.
•
After the bit is guiding itself into the material,
swivel back the machine into the right angle
position.
Advertisement
Table of Contents
