Important Notes To The Installer - Thor Kitchen HRD3001U User Manual

Important Notes to the Installer

1. Read all instructions contained in these installation instructions before installing range.
2. Remove all packing material from the oven compartments before connecting the electrical supply to
the range
3. Anti-tip brackets MUST be installed
4. Observe all governing codes and ordinances.
5.Be sure to leave these instructions with the consumer.
Important Note to the Consumer
Keep these instructions with your owner's guide for future reference.
IMPORTANT SAFETY INSTRUCTIONS
Installation of this range must conform with local codes or, in the absence of local codes, with the
National Fuel Gas Code ANSI Z223.1-latest edition.
This range has been designed certified by the American Gas Association. As with any appliance using gas
and generating heat, there are certain safety precautions you should follow. You will find them in the
Use and Care Guide, read it carefully.
•Air curtain or other overhead hoods, which operate by blowing a downward air flow on to a range, shall
not be used in conjunction with gas ranges other than when the hood and range have been designed,
tested and listen by an independent test laboratory for use in combination with each other.
•Be sure your range is installed and grounded properly by a qualified installer or service technician.
•This range must be electrically grounded in accordance with local codes or, in their absence, with the
National Electrical Code ANSI/NFPA No. 70—latest edition
•The installation of appliances designed for manufactured (mobile) home installation must conform
with Manufactured Home Construction and Safety Standard, title 24CFR, part 3280 [Formerly the
Federal Standard for Mobile Home Construction and Safety, title 24, HUD (part 280)] or when such
standard is not applicable, the Standard for Manufactured Home Installation 1982 (Manufactured Home
Sites, Communities and Setups), ANSI Z225.1/NFPA 501Alatest edition, or with local codes.
•Make sure the wall coverings around the range can withstand the heat generated by the range.
•Before installing the range in an area covered with linoleum or any other synthetic floor covering,
make sure the floor covering can withstand heat at least 90°F/32°C above room temperature without
shrinking, warping or discoloring. Do not install the range over carpeting unless you place an insulating
pad or sheet of 1/4" (6.4 mm) thick plywood between the range and carpeting.
•Do not obstruct the flow of combustion air at the oven vent nor around the base or beneath the
lower front panel of the range. Avoid touching the vent openings or nearby surfaces as they may
become hot while the oven is in operation. This range requires fresh air for proper burner
combustion.
Never leave children alone or unattended in the area where an appliance is in use. As
children grow, teach them the proper, safe use of all appliances. Never leave the oven door open
when the range is unattended.
10