Cycle Guide - Jenn-Air W10665639A User Manual

■ To add rinse aid, open the dispenser lid by gently pushing in the
center of the lid with your thumb while lifting up on the edge.
■
Pour rinse aid into the opening until the indicator level shows that it
is full.
■ Close dispenser by pushing down gently on the lid.
NOTE: For most water conditions, the factory setting
will give good results.
■ If you are experiencing poor drying
performance, you may want to try a higher
setting. Turn the arrow adjuster to a higher
setting to increase the amount of rinse aid.

Cycle Guide

This information covers several different models. Your dishwasher may not have all of the cycles and options described.
The most advanced and versatile cycle. Sensor Wash cycle
senses the load size, soil amount, and toughness of soil, to
adjust the cycle for optimal cleaning using only the amount of
water and energy needed.
Use for hard-to-clean, heavily soiled pots, pans, casseroles,
and tableware.
This cycle, with only the heated dry option selected, and without
other options selected, is recommended to completely wash
and dry a full load of normally soiled dishes. The energy usage
label is based on this cycle and option combination.
Use for lightly soiled items or china and crystal.
When you need fast results, the 1 Hour Wash will clean dishes
using slightly more water and energy. Select the Precision Dry
or Precision Dry
approximately 27 to 35 minutes to the 1 Hour Wash cycle).
Use for refreshing clean items that may be dusty from
infrequent use, or for rinsing soiled items that will not be washed
right away. Do not use detergent.
OPTIONS
Raises the main wash temperature to
improve cleaning for loads containing tough,
baked-on food.
CYCLES
®
+ option to speed drying times (adds
5.
Select a Cycle (cycles vary by
model)
Efficient dishwashers run longer to save water and energy, just as
driving a car slower saves on gas. Typical cycle time is approximately
2¹⁄₂ hours, but can take less or more time to complete depending on
selections.
6.
Select Options (options vary by
model)
You can customize your cycles by pressing the options desired. If you
change your mind, press the option again to turn off the option. Not all
options are available for every cycle. If an invalid option is selected for a
given cycle, the lights will flash.
7.
Start or Resume a Cycle
NOTE: Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
■ Push door firmly closed within 3 seconds of pressing START/
RESUME. If door is not closed within 3 seconds, the Start indicator
will flash, an audible tone will be heard, and cycle will not start.
IMPORTANT: If anyone opens the door (such as, for adding a dish,
even during the Delay Hours option), the START/RESUME button must
be pressed each time.
■ Press START/RESUME to repeat the same cycle and options as in
the previous wash cycle.
SOIL LEVEL
Light to Medium
Tough/Baked-On
Heavy
Heavy/Baked-On
Light
Medium
Heavy
Light to Medium
Heavy/Baked-On
All soil levels
®
All soil levels
CAN BE WHAT IT DOES
SELECTED
WITH
Sensor Wash Raises the main wash
Cookware/
temperature from
Bakeware
105°F (41°C) to either
Normal
130°F or 140°F (55°C
Tableware
or 60°C).
WASH TIME* (MIN.)
W/O OPTIONS
TYPICAL MAX
110 150
125 190
125 190
140 205
110 150
110 150
125 190
105 145
120 185
58 64
17 20
ADDED TIME TO CYCLE
TYPICAL MAX
42 60
WATER
USAGE
GALLONS
(LITERS)
3.8 (14.5)
5.0 (19.1)
7.7 (29.0)
7.9 (30.0)
2.8 (10.5)
4.0 (15.0)
7.9 (30.0)
4.2 (15.2)
7.7 (29.0)
6.2 (23.5)
2.4 (9.0)
ADDED
WATER
GALLONS
(LITERS)
0 - 3.0
(0 - 11.2)