Setup - Polaroid PLA-4248 Owner's Manual

Using the Remote Control
<
Use the remote control by pointing it towards the remote sensor window of the set. Objects between
the remote control and sensor window may prevent proper operation.
Note: This illustration is for reference only. The remote sensor may be in different locations on
different models.
Cautions regarding use of remote control
<
Do not expose the remote control to shock. In addition, do not expose the remote control to liquids,
and do not place in an area with high humidity.
<
Do not install or place the remote control under direct sunlight. The heat may cause deformation of the unit.
<
The remote control may not work properly if the remote sensor window of the main unit is under direct sunlight or strong lighting. In such a
case, change the angle of the lighting or PDP TV set, or operate the remote control closer to the remote sensor window.
Batteries for the Remote Control
1
Open the battery cover.
Precaution on battery use
Improper use of batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions below.
<
Place batteries with their terminals corresponding to the (+) and (–) indications.
<
Different types of batteries have different characteristics. Do not mix batteries of different types.
<
Do not mix old and new batteries. Mixing old and new batteries can shorten the life of new batteries and/or cause old batteries to leak
chemicals.
<
Remove batteries as soon as they are non-operable. Chemicals that leak from batteries can cause a rash. If chemical leakage is found,
wipe with a cloth.
<
The batteries supplied with the product may have a shorter life expectancy due to storage conditions.
<
If the remote control is not used for an extended period of time, remove the batteries from the remote control.

Setup

2
Insert two size-AAbatteries.
<
(Place the batteries with their terminals
corresponding to the (+) and (–) indications
in the battery compartment.)
-
+
-
+
5
5m
3
Replace the cover.