Table of Contents
Advertisement
Changing Volume Lock
The remote comes preset to allow independent volume control of each selected device (Global Volume Unlock). However, you may
change the Volume Lock setting to Global Volume Lock so that one device's volume will control volume in all other modes. After that, you
can perform Individual Volume Unlock on a selected device to set its volume control for independent operation or Global Volume Unlock to
remove all volume locking.
Locking Volume Control to One Mode (Global Volume Lock)
1.
Press and hold
SET
until the red LED blinks twice; then release.
2.
Enter
9-9-3
and then press the mode key for the device you want to control volume (for example,
Now when you press
current mode.
Unlocking All Volume Control (Restoring Global Unlock)
1.
Press and hold
SET
until the red LED blinks twice; then release.
2.
Enter
9-9-3
and then press
Volume is now independently controlled for all programmed devices.
Unlocking a Single Device's Volume Control
1.
Press a device key (
TV, VCR/DVD, CBL/ SAT,
2.
Press and hold
SET
until the red LED blinks twice; then release.
3.
Enter
9-9-3
and then press
Volume is now independently controlled for the selected devices.
Troubleshooting
PROBLEM:
LED does not blink when you press a key.
SOLUTION:
Replace battery with one new 3.3 V 2032 Lithium battery.
PROBLEM:
LED blinks when you press a key, but device does not respond.
SOLUTION:
Make sure the remote is aimed at your device and is not more than 15 feet away.
PROBLEM:
LED blinks one long blink.
SOLUTION:
An entry error has occurred (for example, wrong key). Try entry sequence again.
PROBLEM:
Remote does not control devices or commands are not working properly.
SOLUTION:
Try all listed codes for the device. Make sure the device operates with an infrared remote control.
PROBLEM: CH+ CH-
,
, and
LAST
SOLUTION:
Due to RCA design from 1983 to 1987, only the original remote control will operate these functions.
PROBLEM:
No volume on a device.
SOLUTION:
See "Changing Volume Lock".
PROBLEM:
Channels do not change properly.
SOLUTION:
If the original remote control required you to press
channel number.
VOL+ VOL-
,
, or
Mute
, the selected device (for example,
VOL+
. The LED blinks four times.
or
AUX
VOL-
. The LED blinks four times.
do not work for your RCA TV.
TV
) will control the volume regardless of the
).
Enter
to change channels, press
33
TV
). The LED blinks twice.
Enter
on this remote after entering the
Advertisement
Table of Contents
