14.
Release the swinging ZIF connector (1) to which the keyboard cable is attached, and disconnect
the keyboard cable (2) from the system board.
15.
Remove the keyboard.
16.
Turn the switch cover over.
17.
Remove the two Phillips PM2.0×2.0 broadhead screws (1) from the switch cover.
18.
Remove the LED power button board (2) from the switch cover.
19.
Disconnect the speaker cable (1) from the system board and remove the speaker cable from the
clips and routing channel.
NOTE:
20.
Remove the four Phillips PM2.5×4.0 screws (2) that secure the speakers to the top cover.
ENWW
The two speakers are connected with a single cable.
Component replacement procedures
9