Danby DDR070EAPWDB Use And Care Manual page 13

Operating Instructions
PUMP DRAIN
In situations where the drain hose cannot reach a fl oor drain or if the drain hose needs to reach a
receptacle that is above the level of the unit, water can be automatically drained from the unit using
the pump.
• Unscrew the cap on the back of the unit to access the drain port.
• Connect the provided drain hose to the drain port on the back of the unit.
• Ensure that there are no bends in the drain hose.
• Press the Pump button to initiate the pump drain.
• The maximum length of the pump drain hose is 5 m (16 feet).
Note: The pump drain should be used with the provided drain hose.
INTERNAL PUMP ARM
Inside the unit there is a pump arm that will draw water out of the bucket and then drain it out through
the drain hose. When replacing the bucket in the unit after emptying it, ensure that the pump arm has
not fallen down or the bucket will not go back into the unit.
If the pump arm has fallen down, gently push it up toward the top of the unit until it clicks into place.
10