Advertisement
NOTES: While holding the digit key, the remote will test for the working IR code, causing the INPUT key
to flash each time it tests a new code.
Setup Using Direct Code Entry
This step covers setup for all TV and Audio brands. For faster setup, be sure to locate your device brand
in the code list before beginning setup.
1. Ensure that your TV and/or audio device is powered-on.
Show TV with remote pointed at it.
2. Simultaneously press and hold MENU and OK keys on remote until the INPUT key blinks twice.
Show remote with MENU and OK keys highlighted
3. Enter the 1
complete.
Show remote with digit keys highlighted
4. Test volume functions. If the device responds as expected, setup is complete. If not, repeat
this process using the next code listed for your brand.
Show remote controlling TV.
Assigning Volume Controls
The remote is set to default to control TV volume once the remote is programmed for a TV. If the
remote is also set up to control an audio device, then volume controls will default to that audio device.
If you wish to change volume control settings from these defaults, perform the following steps:
1. Simultaneously press and hold MENU and OK keys on remote until the INPUT key blinks twice.
Show remote with MENU and OK keys highlighted
2. Press the key below for the device that you wish to use for volume controls:
TV Icon = To lock volume controls to the TV, Press VOL +
Audio Icon = To lock volume controls to the audio device, Press VOL-
Cable Box Icon = To lock volume controls to the cable box, Press MUTE
Troubleshooting
Problem:
INPUT key blinks, but remote does not control my equipment.
Solution:
Follow the programing process in this manual to set your remote up to control your
home theater equipment
Problem:
I want to switch VOLUME CONTROLS from to control my TV or to my Audio Device.
Solutions
Follow ASSIGNING VOLUME CONTROLS instructions in this document
Problem:
The INPUT key does not light up on the remote when I press a key
Solution:
Ensure that the batteries are functional and are inserted properly
Replace the batteries with two new AA size batteries
MUG1160S-A1
st
code listed for your brand. The INPUT KEY will blink twice to confirm once
Page 3
Advertisement
