Safecom Mfp Cable Konica Minolta; Safecom Mfp Cable Kyocera Mita - NUANCE SafeCom Controller Administrator's Manual

2 SafeCom Controller
2.6.4

SafeCom MFP Cable Konica Minolta

Locate the MFP's FIH connector inside the MFP.
Remove the male connector with the two wires
and connect the equivalent black connector
from the supplied SafeCom MFP cable.
1. On the MFP's control panel press COPY.
2. Press HELP.
3. Touch Key Ope mode.
4. Touch 3. Scanner.
5. Touch 1. Initial Setting.
6. Scroll to SCAN W/O key count and touch EDIT to change this setting to
Not valid.
7. Touch RETURN.
8. Touch RETURN.
9. Touch RETURN.
1. Set Dipswitch 01-0 to OFF (0) so that the operation of the key counter
removal is the same as the stop key, instead of immediate stop (jam).
2. Please ensure that printing is possible without key counter.
Note: On the SafeCom Controller's Printer web page (2.7.4) you need to set
Printer Manufacturer to OCE. If you try to make copies without being logged
in via SafeCom, the MFP's control panel displays Please insert key counter.
2.6.5

SafeCom MFP Cable Kyocera Mita

1. Remove the MFP's rear cover.
2. Locate the 4-pin connector of the MFP's key counter wire at the top left
corner inside the printer. The connector's 4 wires are colored blue,
yellow, red and turquoise.
3. Connect the SafeCom MFP Cable's white connector to the MFP's FIH
connector.
4. Mount the MFP's rear cover back on.
5. On the MFP' control panel press the COPY button. Enter the 8-digit code
to bring the MFP into maintenance mode.
6. Enter the maintenance number 204 and press Start to set key-card/key-
counter.
7. Touch KEY-COUNTER and press Start.
8. Enter the maintenance number 001 and press Start to return to normal
copy mode.
Note: On the SafeCom Controller's Printer web page (2.7.4) you need to set
Printer Manufacturer to KYOCERA. If you try to make copies without being
logged in via SafeCom, the MFP's control panel displays Insert key counter.
D60700-07 24