Inspection And Repair - CMC Rescue MPD User Manual

ABOUT THE MPD
18
INSPECTION
Inspect the MPD according to your department's policy for inspecting life
safety equipment. Equipment should be inspected after each use by an
inspector that meets your department's training standard for inspection of
life safety equipment. Record the date of the inspection and the results in
the equipment log. Each user should be trained in equipment inspection and
should do a cursory inspection before each use.
The MPD should be inspected after each use to ensure that damage did not
occur. When inspecting, look for any damaged, dirty or sticking components,
excessive wear or any other factor that may prevent proper function. If any
significant damage is observed, the equipment should be retired from
service.
The MPD must be inspected after an impact load has occurred. Inspect for
any damage to the components. Evaluate the sheave for smooth operation
of the bearing. If any damage or indications of improper function are
noted, the MPD should be immediately retired from service.
REPAIR
All repair work shall be performed by the manufacturer. Other work or
modifications may void the warranty and shall release CMC Rescue, Inc.
from all liability and responsibility.
For information or service contact:
CMC Rescue, Inc.
6740 Cortona Drive, Goleta, CA 93117 USA
(800) 235-5741 or (805) 562-9120
support@cmcrescue.com
cmcrescue.com