Fitting The Batteries; Setting Personal Data - Black & Decker BK60W Original Instructions Manual

English
(Original Instructions)
 Use only the correct type of battery for the
appliance (see technical data)
 Never attempt to charge non-rechargeable
batteries.
 The electronic components inside the
appliance may be affected by other devices
used in close proximity, such as mobile
phones or microwave ovens. If this happens,
the display will show erroneous data. To
remedy this, either switch the interfering device
off, or move the appliance away from it.
Additional safety instructions for non-
rechargeable batteries.
 Never attempt to open for any reason.
 Do not store in locations where the
temperature may exceed 40 °C.
 When disposing of batteries, follow the
instructions given in the section "Protecting the
environment".
 Do not incinerate batteries.
 Under extreme conditions, battery leakage may
occur. When you notice liquid on the batteries,
proceed as follows:
- Carefully wipe with the liquid off with a damp
cloth.
- Avoid skin contact.
 The batteries and battery compartment should
be checked periodically for any signs of
corrosion.
Assembly

Fitting the batteries

 Remove the battery cover from the appliance.
4
 Insert 2 batteries (CR2032) into the appliance.
 Refit the battery cover.
Note! The appliance display will show " Lo" if
there is insufficient power in the batteries. If this
occurs then change the batteries.
Use
 Place the appliance on a flat surface.
 Ensure the appliance is dry before stepping on
to it.

Setting personal data

The memory can store personal data for up to 12
people.
 Switch the appliance on.
 " 8888 " will appear in the display (4).
 Press the set button (3).
 " -01- " will appear blinking in the display (4).
 Select the user number by pressing the up or
down button (2).
 Confirm the selection by pressing the set
button (3)
 Enter the data in the menus appearing in the
order as follows.
Selecting the gender
The screen will display the gender by a female
or a male symbol.
 Select the gender by pressing up or down
button (2).
 Store the data by pressing the set button (3).