Section 3 − Definitions; Additional Safety Symbols And Definitions - Miller Coolmate 1.3 Owner's Manual

3-1. Additional Safety Symbols And Definitions

.
Some symbols are found only on CE products.
Warning! Watch Out! There are possible hazards as shown by the symbols.
Do not remove or paint over (cover) the label.
Disconnect input plug or power before working on machine.
Do not discard product (where applicable) with general waste.
Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection
facility.
Contact your local recycling office or your local distributor for further information.
Use coolant suggested by the manufacturer: 043810 (HF), 043809 (Al).
XXXXX
100 h. Std.
.
A complete Parts List is available at www.MillerWelds.com
SECTION 3 − DEFINITIONS
Plugged filter or hoses can cause overheating to the power source
and torch.
Every 100 hours, check and clean filter and check condition of hoses.
Read the labels on the welding power source, wire feeder, or other
major equipment for welding safety information.
Read the Owner's Manual before working on this machine.
Safe1 2012−05
Safe20 2012−05
Safe30 2012−05
Safe37 2012−05
Safe52 2012−05
Safe50 2012−05
Safe51 2012−05
Safe71 2012−06
Safe70 2012−06
OM-257811 Page 5