GE 2-9896 Use & Care Manual page 12

REMOTE
OPERATION
When you call your Answer-Phone from another location using a
touch tone phone, you can enter your three digit security code.
(This code is factory preset and written on the bottom of the unit.)
Your messages will be played back automatically. After playback,
you will hear 3 beeps. You may then enter a command to request
one of the other features normally available to you at home. For
future reference, write your three digit security code in the spaces
provided on your remote card found in the fold out in this book.
Notes: Remote functions will not work with rotary, or push button
pulse dialing phones.
After a remote command is completed you will hear three short
beeps. You have ten seconds to enter a new command or hang up.
You can press any key from a touch tone phone while the outgoing
message is playing to bypass the announcement. The unit will sound
a beep. You may leave a message or dial the three digit security code
to enter remote operations.
To Play Messages
1. Dial phone number of Answer-Phone.
• After (OGA) wait until you hear a beep.
2. Dial three digit security code after beep.
• Unit will beep once and voice will say "PLEASE WAIT". Then
unit will rewind to the beginning of the messages and play them
back. (Note: you will hear a melody until the beginning of the
tape is reached.)
3. Unit will beep three times when finished.
4. You have ten seconds to enter another remote command or hang
up.
To Replay Messages
1. Press 2 to replay messages.
2. Unit rewinds tape. A voice will say "PLEASE WAIT". Then you will
hear a melody until the beginning of the tape is reached .
3. Unit will play messages.
4. Unit will beep three times when finished.
22
• Press 2 again while unit is playing to quit playback. A voice will
say "PLEASE WAIT". Then you will hear a melody until the end
of the messages is reached.
• A.
Introduction
B.
Outgoing
Annoucement
(OGA) Bypass
• C.
Remote
Message
Playback
. . .
. .
To Review Messages
During message playback, press
1
and hold down until the desired
amount of tape has been rewound. Unit continues playback from
point REWIND button is released.
To Skip Messages
During message playback, press 9 and hold down to fast forward.
Unit continues playback from point FAST FORWARD button is
released.
To Reset Incoming Message Tape
1. After hearing three short beeps Press 8 to reset.
2.
Unit will beep three times.
3. Press 2 to replay messages and restore message count.
To Leave a Remote Memo
1. After hearing three short beeps press 5.
2. Wait one second after beep, then speak.
3. Press 5 when finished.
4.
Unit will stop recording.
5. Unit will beep three times.
To Record a New Outgoing Announcement
1.
After hearing three short beeps, Press
4 .
2.
Wait one second after beep, record new announcement. You
have up to twenty seconds.
3.
Press 4 when finished.
• New announcement wi ll automatically playback.
4. Unit will beep three times.
REMOTE
OPERATION
D.
Remote
Message
Review and
Skip
E.
To Reset
Incoming
Message
F.
Remote
Memo
G.
Remote
Announcement
Change
23