Advertisement
2. master-to-master control ( condomunium control )
With sufficient natural
light, the light does
not switch on when
presence detected.
With insufficient nature
light, the person comes
from any direction, the
group of lamps switch on.
After the hold time,the
whole group of lamps
dims to pre-defined
dimming level when no
movement detected.
After the stand-by
period,the whole group
of lamps switches off
automatically.
3. 100H burn-in mode for fluorescent lamp
With simple operation, rapidly turn off/on the fixture 3 cycles within 3 sec. (the green LED on the sensor
flashes and the fixture blinks 3 times to indicate the success of setup), lamp will be 100% on for 100
hours, and then automatically goes to sensor mode after 100 hours. This is crucial to secure the lifetime
of fluorescent lamp, when new fixture is installed, or old lamp is replaced.
This 100h burn-in feature can be cancelled by turning off/on the fixture 1 cycle within 1sec.
4. zero-cross relay operation
designed in the software, the sensor swith on/off the load right on the zero-cross point, to
ensure the min. current passing through the relay contact point, and enbale the maxi. load and
life-time of the relay.
2
Add: 1501 Industrial Way N, Toms River, NJ 08755 Phone: 866-222-8866 E-mail: info@abovealllighting.com
Web: www.AboveAllLighting.com ©2016 ABOVE ALL Lighting, Inc. All rights reserved
Microwave Motion Sensor HC419V
Instructions Manual
Advertisement
