Pvt Drying - Polaris Sportsman 9920374 Owner's Manual

MAINTENANCE
PVT System
When To Use Low Range and High Range
Operating at speeds less than 7 MPH (11 km/h)
Towing heavy loads
Operating in rough terrain (swamps, mountains, etc.)
Operating at speeds greater than 7 MPH (11 km/h)

PVT Drying

There may be some instances when water is accidently ingested into the
PVT system. Use the following instructions to dry it out before operat-
ing.
1. Position the vehicle on a level surface.
2. Remove the drain plug. Allow the water to drain completely. Rein-
stall the drain plug.
3. Start the engine. Place the transmission in PARK.
4. Apply varying throttle for 10-15 seconds to expel the moisture and
air-dry the belt and clutches.
NOTE:
Do not hold the throttle wide open for more than 10 seconds.
5. Allow the engine RPM to settle to idle speed, then shift the trans-
mission to the lowest available range.
6. Test for belt slippage. If the belt slips, repeat the process.
7. Take the vehicle to your dealer for service as soon as possible.
104
Condition Range to Use
Low
Low
Low
High