Campbell Hausfeld CC2300 Operating Instruction page 5

12-Volt DC Recharging
This unit is NOT intended for recharging a car battery.
Never start the car (vehicle) when the 12-volt DC recharging adapter is plugged into the
cigarette lighter.
NOTE: Charging the battery while the car engine is not running drains the car battery and is not
recommended. If the unit is used too long after the yellow light comes on, recharging time could take up to
7 hours.
To recharge the battery using the 12-volt DC adapter while driving, follow the subsequent procedures:
1. Insert the 12-volt DC recharging adapter into the 12-volt DC output socket.
2. Insert the other end into the cigarette lighter and rotate to make a good electrical contact.
3. The inflator should be charged for 5 to 6 hours while driving before the initial use. After multiple uses,
recharge the inflator for 3 hours.
Battery Indicator Lights
Green and yellow lights show the battery condition while the compressor switch is
in the off position. The green light indicates a charged battery. The yellow light indicates the battery is low
and needs recharging. The red light indicates the AC charger is connected and charging.
If the battery is drained after the green light is off, the life of the battery may be shortened.
GREEN LIGHT YELLOW LIGHT
ON
ON
OFF
OFF
* While the compressor switch is in the off position.
Inflation Instructions
Do not leave the inflator unattended while the unit is running.
The universal adapter must be locked to secure the inflation accessories. Any misuse could
cause property damage or personal injury. Use extreme caution when using inflation
accessories.
Turn unit off to allow inflator to cool for 20 minutes after 20 minutes of continuous operation.
If not cooled properly the inflator will overheat.
Make sure the universal adapter touches the core of tire valve stem.
After the battery is charged, the inflator is ready for use. If the battery has not been charged, see sections
120-VOLT AC CHARGING or 12-VOLT DC CHARGING before continuing.
1. Remove valve stem cap. Attach the universal
adapter from the air inflator to the valve stem
with the lever in the up position. Be sure to
press universal adapter down over valve stem
threads completely. When universal adapter is
firmly in place, press locking lever down to lock
onto valve stem (See Fig 1).
2. To use the inflation accessories, insert piece into
the universal adapter and push the lever to lock
into place
(See Figure 1). The inflation accessory will fit
securely.
3. Insert the appropriate inflation accessory into
the inflatable object.
4. Turn on the power and the compressor switch.
5. When the object is firm, turn the inflator off. Do not over inflate objects.
RED LIGHT
OFF OFF
ON OFF
ON OFF
OFF ON
Figure 1
3
BATTERY INDICATION *
Full to Normal
Weak, Needs Recharging
Exhausted, Needs Recharging IMMEDIATELY
AC Charger Connected
Universal
Adapter
LOCK
Valve Stem