EBLOCKER pro User Manual page 69

Enter a name and description for this VPN network. Finally, decide if you wish the VPN network to be
available in the eBlocker controlbar by clicking on the switch slide. If you do not want the connection
to be shown in the controlbar, it will only be visible in your settings and displayed as inactive.
You have successfully created a new VPN network and can edit, remove, or run a connection test
with a click on the name.
In the eBlocker Controlbar, you will see the VPN network you have just created under the "Anon"
menu item. The connection is verified by clicking on the VPN network, and a check mark is displayed
to indicate successful connection to the VPN network. If the connection was not successful, no check
mark would be displayed. In this case, go back to settings and verify your username and password.
After activating the VPN network, the Anon icon in the control bar is filled with a checked pattern to
indicate it is active.
To disconnect the VPN connection click on the anon icon first and afterwards on the VPN icon. The
checked pattern on the anon icon will then be removed again.
Page 69 of 81
17.10.2017