Download Print this page

Black & Decker BDJS450IAU Instruction Manual

450 amp slim jump starter with compressor


Quick Links

• The compressor may be
overheated. Press the
compressor power switch to
will not
turn the compressor off. Restart
after a cooling down period of
approximately 30 minutes.
• Check that the unit has a full
charge. Recharge the unit if
This unit has been designed to operate over a long
period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon
proper tool care and regular cleaning.
Warning! Before performing any maintenance or
cleaning of the unit, unplug it from the power supply.
• From time to time wipe the unit with a damp cloth.
Do not use any abrasive or solvent-based cleaner. Do
not immerse the unit in water.
• Clean the outside case of the jump starter with a soft
cloth and, if necessary, mild soap solution.
• Do not allow liquid to enter the unit'. Do not operate
when the battery charger is wet.
• Keep the cords loosely coiled during storage to
prevent damage to the cords.
Correct disposal of this product
This marking indicates that this product
should not be disposed with other
household waste throughout the EU. To
prevent possible harm to the environment
or human health from uncontrolled
waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources. To return
your used device, please use the return and collection
systems or contact the retailer where the product
was purchased. They can take this product for
environmentally safe recycling.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the
demand for raw materials.
Local regulations may provide for separate collection
of electrical products from the household, at municipal
waste sites or by the retailer when you purchase a
new product.
Battery Type
12V, 17Ah, sealed lead
Output (instant)
Output (constant for
5 seconds)
BDJS450IAU_Manual_091216.indd 8-1
Pressure (max)
bar/p.s.i 8.27/120
Mains charging adapter
100-240V ac, 50/60Hz
14,5V dc (750mA)
Our goods come with guarantees that cannot be
excluded under the Australian & New Zealand
Consumer Law. You are entitled to a replacement
or refund for a major failure and compensation
for any other reasonably foreseeable loss or
damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of
acceptable quality and the failure does not
amount to a major failure.
Baccus Worldwide LLC is confident of the quality of
its products and offers an outstanding warranty. This
warranty statement is in addition to and in no way
prejudices your statutory rights under the Australian &
New Zealand Consumer Law.
If a Baccus Worldwide LLC product becomes
defective due to faulty materials, workmanship or
lack of conformity, within 24 months from the date
of purchase, Baccus Worldwide LLC guarantees to
replace defective parts, repair products subjected to
fair wear and tear or replace such products to make
sure of the minimum inconvenience to the customer
• The product has been used for trade, professional or
hire purposes;
• The product has been subjected to misuse or
• The product has sustained damage through foreign
objects, substances or accidents;
• Repairs have been attempted by persons other than
Baccus Worldwide LLC service staff.
To claim on this warranty, you will need to submit
proof of purchase and return the allegedly defective
product to Baccus Worldwide LLC's local market
distributor, at your expense.
Please visit our website
to register your new Baccus Worldwide LLC product
and to be kept up to date on new products and special
offers. Further information on the Baccus Worldwide
LLC brand and our range of products is available at
Distributed by: Directed Electronics
Address: 44 Translink Drive, Keilor Park Victoria Australia 3042
PH: + 61 03 8331 4800 Email:
Baccus Worldwide LLC
Weena 290, 3012 NJ Rotterdam or
Postbus 819, 3000 AV Rotterdam
+31(0)10 282 16 11
Cat. # BDJS450IAU
September 2016
Printed in China
9/12/2016 11:57:44 AM



Summary of Contents for Black & Decker BDJS450IAU

  • Page 1 12V, 17Ah, sealed lead Baccus Worldwide LLC Weena 290, 3012 NJ Rotterdam or acid Postbus 819, 3000 AV Rotterdam Output (instant) 450A Cat. # BDJS450IAU September 2016 +31(0)10 282 16 11 Output (constant for RD091216 Printed in China 5 seconds) 300A BDJS450IAU_Manual_091216.indd 8-1...
  • Page 2 INSTRUCTION MANUAL • The appliance should be protected from direct sunlight, heat and moisture. Inspection and repairs INTENDED USE • Before use, check the appliance for damaged or Your Black & Decker jump starter is designed to defective parts. Check for breakage of parts, damage provide additional power to lead-acid batteries when to switches and any other conditions that may affect starting car engines;...
  • Page 3 • Check the polarity of the vehicle battery terminals Warning!To avoid the risk of personal injury or • Do not use the compressor when the charger is Your charger meets the Energy before connecting the appliance. Always disconnect property damage: connected to the mains.
  • Page 4 • In case of eye contact, rinse immediately with clean • Charge the unit until the green battery status LED 9. When the vehicle starts, turn the jump-starter off/ 3. Turn on the compressor power switch — inflate water and seek immediate medical attention. lights or flashes.