Troubleshooting - Parts Connect IM70 User Manual

Before Calling for Service
f the unit appears to be malfunctioning, read through the OPERATION section of this manual
I
first. If the problem persists, check the Troubleshooting Guide below and on the following page.
The problem could be something very simple that can be solved without a service call
Problem
The machine
doesn't operate.
The water doesn't
feed in after the
machine starts.
Machine makes ice,
but ice storage bin
does not fill up with
ice.
Water is leaking from
the unit.
Cubes are partially
formed or are white
at the bottom.
26

TROUBlESHOOTING

Troubleshooting Guide
Possible Cause
The ice machine is unplugged.
The circuit breaker or fuse is blown.
The Power switch is set at O/OFF.
The ice storage bin is full of ice.
The water supply tap is turned off.
The water supply line is not
properly connected.
Condenser may be dirty.
The air flow to the ice machine
may be obstructed.
The ambient temperature and water
temperature are high, or machine is
near some heat source.
A few water drops fall to the floor
when you open the door to take out
ice from storage bin.
Water supply connection is leaking.
Not enough water in the water
tough.
Probable Correction
Plug the ice machine in.
Replace fuse – if this happens
again, call for service to check for a
short circuit in the ice machine.
Turn the Power switch to I/ON.
Remove some ice, making sure the
ice-full flap is free of ice.
Turn on the water supply tap.
Reconnect the water supply line.
Clean the condenser.
Check the installation.
Check the installation.
Normal condensation on the door
or some water together with ice.
Be careful when you take out ice.
Tighten fitting. See
"Connecting the Water Line".
Check if the water supply pressure
is below 15 psig.
Check water supply; filter may be
restricted.
Check for a water leak at the water
trough.
.