Samsung AM***KNTD** User Manual page 46

Installation Procedure
Please refer to the EEV step table below for the system (for heating) at stop.
Indication
Wall MountedWith EEV
Stopped
Unit's
EEV step
Other Indoor Units except for wall
mounted with EEV
(*4) When the following 2 or 3 is used as external heater On/Off signal, the signal for monitoring external contact control
will not be output.
2: Fan is turned on continually when the external heater is turned on,
3: Fan is turned off when the external heater is turned on with cooling only indoor unit
Cooling only indoor unit: To use this option,install the Mode Select switch(MCM-C200) on the outdoor unit and fix it
as cool mode.·
• If Fan is set to off for cooling only indoor unit by setting the SEG9=3 or SEG15=3, you need to use an external
sensor or wired remote control sensor to detect indoor temperature exactly.
(*5) Default setting value
– 4Way Cassette, Mini 4Way Cassette: 5 °C
– Other indoor units: 2 °C
(*6) This function can be applied to 4 Way Cassette and Mini 4 Way Cassette only. If the air conditioner operates the
heating mode immediately after finishing the cooling mode, the condensated water in the drain pan becomes water
vapor by the heat of the indoor unit heat exchanger. Since the water vapor might be condensed on the indoor unit,
which may fall into a living space, use this function to get rid of the water vapor out of the indoor unit by operating
the fan (for maximum 20 minutes) even when the indoor unit is turned off after cooling mode is turned to heating
mode.
46 English
DVM_BORACAY_IB_DB68-06415A-00_EN.indb 46
0 2 3
A Step 100 90 100 110
B Step 125 160 160 160
Default
4 5 6 7 8
120 130 160 200
160 160 160 200
No Function
9 A B
250 300 400
250 300 400
2016-08-31 오후 2:13:31