Polaris 340 Classic Owner's Manual page 43

Edge Touring Suspension (ETS) Adjustments
Torsion Springs
Two torsion springs are used on the rear arm of
the ETS. Preload adjustments can be made by
turning the rectangular adjusters with a spark
plug wrench.
The firm torsion spring should be used if
frequent bottoming is encountered during two
up riding on rough trails.
The soft torsion spring should be used for
frequent one up riding on smooth trails.
For soft tension, position the long end of the
cam to the front (A). For firm tension, position
the long end of the cam up (B).
Front Track Spring and Preload
Front track spring and preload can also be
adjusted. Turn the screw (C) clockwise to
tighten compression (stiffen). Turn the
spring (D) clockwise to tighten preload.
Initial Setup Reference Chart
This chart is only a guideline for initial suspension setup. Your setup
may vary based on your desired riding style.
1 Rider Soft
Firm
2 Riders Soft
Firm
Soft
Firm
Torsion
Spring & Block
Setting
Low
Med
Med
High
Optional Torsion Spring
Left Hand
7042139-067
7042282-067
THE PERFECT FIT
RCA Front Track
Position Spring Preload
(Inches)
1-2 0.25
2-3 0.50
3-4 0.75
4-5 1.00 max
Right Hand
7042140-067
7042283-067
D
C
Front Track
Indy Select -
Turns From
Full Open
0-1
1-2
1-3
2-3
Optional Front Track
Spring
7041351-067
-------------
A
B
41