Table of Contents
Advertisement
3.2
Monitor section
3.2.1 Removing the front bracket
(See Fig.20)
(1) Remove the two screws W attaching the FPC cover.
(2) Remove the four screws X and four screws Y attaching the
front bracket assembly.
(3) Disengage the four hooks b and remove the front bracket
assembly.
Caution:
In this time, FPC cover come off to easy, do not lost it.
3.2.2 Removing the display unit
(See Fig.21)
(1) Disconnect the card wires from connector
CN423
of the panel board.
(2) From both side of the display unit, remove the four screws
Z attaching the display unit.
(3) Disengage the six hooks c and remove the display unit.
3.2.3 Removing the panel board
(See Fig.22)
(1) Disconnect the flexible wire from connector
panel board.
(2) Disconnect the connector wire from connector
the panel board.
(3) Remove the one screw AA attaching the earth wire.
(4) Flat to two bending part d of the panel bracket and then re-
move the panel board.
1-14 (No.MA261)
Y
X
Y
CN422
and
CN423
Z
CN411
of the
CN471
of
b
b
W
b
Fig.20
c
c
Fig.21
d
CN411
Fig.22
Y
X
Y
CN422
Z
AA
CN471
Advertisement
Table of Contents
