Maintenance - Westinghouse TR18361 Instruction Manual

F21
F22
F23
F24
F25
the guide bar from being caught in the cut.
A L o g l y i n g o n t h e g r o u n d (F21)
Saw down halfway, then roll the
log over and cut from the opposite side.
A L o g h an g i n g o f f t h e g r o u n d (F22)
In area A, saw up from the bottom one-third and
finish by sawing down from the top. In area B, saw
down from the top one-third and finish by sawing up
from the bottom.
Cu t t i n g L i m b o f Fal l en Tr ee (F23)
First check to which side the limb is bent.
Then make the initial cut from the bent side and
finish by sawing from the opposite side.
WARNING
!
Be alert to the springing back of a cut limb.
Pruning of Standing Tree(F24)
Cut up from the bottom, finish down from the top.
WARNING
!
Do not use an unstable foothold or ladder.
Do not overreach.
Dot not cut above shoulder height.
Always use your both hands to grip the saw.

9. MAINTENANCE

WARNING
!
Before cleaning, inspecting, or repairing your
unit, make sure that engine has stopped and is
cool. Disconnect the spark plug to prevent
accidental starting.
MAINTENANCE AFTER EACH USE
1.A i r f i l t er
Dust on the cleaner surface can be removed by
tapping a corner of the cleaner against a hard
surface. To clean dirt in the meshes, split the cleaner
in. o halves and brush in gasoline. When using
compressed air, blow from the inside.(F25)
2.Oi l i n g p o r t
Dismount the guide bar and check the