Advertisement
Adjusting the Volume
Turn the On/Off/Volume Control Knob clockwise
to increase volume or counterclockwise to
decrease volume.
NOTE: Your radio can be programmed to have a
minimum volume offset where the
volume level cannot be turned down
fully. Check with your dealer or system
administrator for more information.
Audio Indicators for Programmable
Buttons
Some programmable buttons use audio
indicators to indicate the change as they
alternate between two different choices.
Programmable
Positive
Button
Indicator Tone
Currently in
Zone
Zone 2
Repeater/
Currently in
Talkaround
Talkaround mode
Start Scan
Scan
operation
Operating in
Squelch
tight squelch
Transmitting at
Power Level
low power
Tones and
All tones and
Alerts
alerts are on
English
Accessing the Radio from Password
Power up the radio.
1
You hear a continuous tone.
2
Use the Channel Selector Knob to enter the
first digit of the password.
3
Press Side Button 1, 2 or 3 to enter each digit
of the remaining three digits of the password.
You hear a positive indicator tone for each
Side Button press.
When the second digit of the password is
entered, your radio ignores any Channel
Selector Knob position change.
4
When the last digit of the four-digit password
is entered, your radio automatically checks
Negative
the validity of the password.
Indicator Tone
If the password is correct:
Currently in
Your radio proceeds to power up.
Zone 1
OR
If the password is incorrect:
Currently in
Repeater mode
You hear a continuous tone. Repeat Steps 1
to 3.
Stop Scan
OR
operation
After the third incorrect password, your radio
Operating in
enters into locked state. A tone sounds and
normal squelch
the LED double blinks yellow.
Transmitting at
high power
All tones and
alerts are off
Your radio enters into locked state for 15
minutes, and responds to inputs from On/Off/
Volume Control Knob.
NOTE: The radio is unable to receive any call,
including emergency calls, in locked
state.
Selecting a Zone
1
Press the programmed Zone button.
2
You hear a positive indicator tone, indicating
the radio has switched from Zone 1 to Zone 2.
OR
You hear a negative indicator tone, indicating
the radio has switched from Zone 2 to Zone 1.
Selecting a Radio Channel,
Subscriber ID, or Group ID
1
Turn the On/Off/Volume Control Knob to
power up your radio.
2
Turn the Channel Selector Knob to select the
required channel, subscriber ID, or group ID.
Capacity Plus
Turn the Channel Selector Knob clockwise or
counterclockwise to access channels with
Capacity Plus.
Advertisement
