Switching The Unit On - DEHACO NANO User Manual

DEHACO B.V.
Kruisbaak 25, 2165 AJ Lisserbroek (NL)
P.O. Box 189, 2160 AD Lisse (NL)
Tel.:+31(0)252 417 950, fax 418 531
www.dehaco.nl
info@dehaco.nl

8. Switching the unit on

Before connecting the water hose, first flush it out in order to avoid dust or grit
in the hose and that the spray unit will become dirty and/or obstructed.
a
b
d
c
e
f
a
User manual
a= waterflow controller
b= water connection
c= on/off switch
d= reset button thermal protection
e= power cable 220V
f= speed control fan
1. Place the Dehaco NANO close enough to the work area but
not so close that it gets in your way or can be hit by falling
objects. Turn off the water flow (a).
2. Clean the water hose connector (b) and connect it.
3. Place the plug in the plug socket.
4. Switch on the spray unit (c).
5. Adjust the desired speed of the fan (f).
6. Open the waterflow controller (a) carefully into desired
position.
7. Turn the nebuliser in the desired angle.
Using a different order for switching on the unit is not
harmful,
but not very practical:
- if you open the water flow controller before switching on the
unit, it will start leaking.
- the fan may be put on the position "0" when the nebuliser is
turned on, this will cause no damage.
- the nebuliser may run "dry", this will not cause damage.
b
DEHACO-NANO v2.0-en
ATTENTION!!
oct 2010 page- 8-