Table of Contents Introduction ......................... 3 Disclaimer ........................3 Important safety advice....................3 Notes for usage and installation ................. 4 In case you encounter an error ................... 4 Designated use ......................5 1. General Introduction ..................... 5 1.1. Overview ......................5 1.2.
The warranty will expire for damage due to non-compliance with these operating instructions. LUPUS-Electronics will not be liable for any consequential loss! LUPUS-Electronics will not accept liability for damage to property or personal injury caused by incorrect handling or non-compliance with the safety-instructions. In such cases the warranty will expire.
Notes for usage and installation This camera is a high quality surveillance device. Please keep the following security information in mind: Do never angle the camera directly into the sun. Do never angle the camera directly into a spotlight. ...
Designated use When you install the camera make sure that you do not violate the personal rights of others. Any usage which is not described in this manual is not allowed and leads to a loss of warranty, as well as, a decline of liability. This also includes modifications. 1.
Protection class: IP66 The LUPUSNIGHT – LE 138HD and LE 139HD features an OSD (on-screen-display) to allow individual setup. Runs on a DC 12V power supply. 2. Framework and Dimensions of the LUPUSNIGHT – LE 138HD and 139HD Please refer to the following figures for dimension information.
3. Installation of the LUPUSNIGHT – LE 138HD and 139HD IMPORTANT: Before you install the camera, please make sure that the surface on which you install the camera can at least support 3x the weight of the camera. Figure 3-1 LUPUSNIGHT – LE 138HD / 139HD Step 1: Use the installation position map to mark the place of installation you have chosen for your camera.
Figure 3-2 Options to adjust the camera angle of your LUPUSNIGHT – LE 138Hd / 139HD Step 5: Connect the camera via a coaxial cable to your HDTV recorder and, then, connect the power cable to your power source. The camera will now boot and your HDTV recorder will receive an image from the camera.
To open the OSD menu via the Web interface of your HDTV recorder, please proceed as follows: Open the single image view of a camera and click on the black bar on the right to open the PTZ options ...
Page 10
0 – 100 Sharp suppression 0 – 100 Chroma suppression 0 – 15 Gamma 2DNR 0 - 100 0 – 100 3DNR 0 – 100 Exposure Auto Gain max 0 – 100 Gain min 0 – 14 Exposure level 0 – 7 Exposure speed Anti-flicker Outdoor...
Page 11
Please visit our website or contact your local service engineer for more information. ® LUPUS-Electronics GmbH Otto-Hahn-Str. 12, D-76829 Landau Tel. +49 (0) 6341 93 55 3 0 Fax. +49 (0) 6341 93 55 3 20 E-Mail: info@Lupus-Electronics.de www.Lupus-Electronics.de...
Need help?
Do you have a question about the LUPUSNIGHT-LE 138HD and is the answer not in the manual?
Questions and answers