Bowers & Wilkins P7 Manual page 5

The P7 Wireless Bluetooth indicator will flash
continuously while pairing is underway and will
also provide audible feedback when pairing is
established.
Note: If your Bluetooth audio source device does
not support "simple" pairing and requests a four
digit code, enter '0000'.
Once a connection has been established, ensure
that P7 Wireless is selected as the speaker output
for the Bluetooth source device. Audio will then be
heard through P7 Wireless.
Note: If pairing fails the indicator will flash in
2 second bursts. The most common reasons for
pairing failure are signal interference and distance
between the two devices. It is good practice to
have the two devices relatively close to each
other when pairing.
To disconnect a Bluetooth source device from
P7 Wireless press the Bluetooth button twice in
quick succession. This will disconnect all Bluetooth
connected devices. P7 Wireless will provide audible
feedback when Bluetooth is disconnected.
P7 Wireless paired device memory can be cleared
by pressing and holding Volume – and Bluetooth
button for 2 seconds. The indicator will flash and
P7 Wireless will restart once its memory has been
cleared.
7. Controlling Bluetooth Audio
The P7 Wireless Play/Pause, Volume + and Volume –
buttons can be used to control Bluetooth audio:
Note: The buttons are not operational when P7
Wireless is used in passive mode with a wired
connection.
To increase volume press and hold the Vol + button.
To decrease volume press and hold the Vol – button.
To play audio press and release the Play/ Pause
button.
To pause audio press and release the Play/ Pause
button.
To select the next track press the Play/ Pause button
twice in quick succession.
To select the previous track press the Play/ Pause
button three times in quick succession.
8. Using a mobile phone with your
P7 Wireless
To answer a call press and release the Play/Pause
button.
To reject a call press the Play/Pause button for
2 seconds.
To end a call press and release the Play/Pause
button.
A Bluetooth stream playing while a telephone call is
taken will be paused. It will resume when the call is
ended.
9. P7 Wireless wired connection
In addition to operating wirelessly, your P7 Wireless
can be connected to a music source using the
supplied universal cable. Cable connection is useful
if the battery is low or if P7 Wireless is to be used
with a non-Bluetooth audio source device.
To connect the supplied cable to your P7 Wireless
proceed as described in the following steps and
illustrated in Diagram 5.
Carefully pull the left ear pad away from the body of
the ear piece. The ear pad is held magnetically and
will detach with little effort.
Take one end of the connection cable and carefully
insert it into the socket beneath the ear pad. Dress
the cable as illustrated in Diagram 5.
Diagram 5
Attaching the audio cable
Replace the ear pad.
The universal cable must be disconnected for P7
Wireless to switch on and connect via Bluetooth,
however its battery can be charged while the
universal cable is connected.
Note: Connecting the universal cable will
automatically switch off the Bluetooth and
powered elements of P7 Wireless. P7 Wireless
will not however switch on automatically when
the universal cable is disconnected.
5