Set Telephone/Amplifier; Connect To Device - Plantronics MX10 User Manual

Switcher.biling.ii-25 11/4/98 7:58 PM

set telephone/amplifier

4
S T E P
1. Put on headset.
2. Lift the phone's handset off the cradle and place
it on your desk.
3. If you don't hear a dial tone, adjust the
Telephone/Amplifier Compatibility Switch as
indicated below:
1. Remove the Telephone Compatibility Switch Access
Door by placing two fingers or thumbs on the
raised bumps and pushing down.
2. Remove the flat, plastic screwdriver from the
bottom of the amplifier by sliding it through the
braces holding it in place.
3. Make sure the amplifier is in the default settings,
and your telephone handset is off of its cradle.
4. Using the screwdriver, slide the Compatibility
Switch until you hear a clear dial tone.
Experimenting with various switch settings will
not harm the amplifier or your telephone.
e n g l i s h
4
Page 4
I N S T A L L A T I O N S T E P S
C o m p a t i b i l i t y S w i t c h
I N S T A L L A T I O N S T E P S
connect to
5
S T E P
a n a u d i o d e v i c e
1. Plug the single-jack end of the
Audio Device Cable (mini-DIN) into the
external audio device jack on the rear
panel of the amplifier.
2. Plug the twin jack end of the Audio
Device Cable into the audio device,
matching the icons.
e n g l i s h
MIC
Line Out
SPKR
5