JVC RX-6042S Service Manual page 6

3.3 Removing the rear panel
(See Fig.4)
• Prior to performing the following procedure, remove the top
cover.
(1) From the back side of the main body, remove the strain
relief from the rear panel in the direction of the arrow.
(2) Remove the twenty-six screws E and four screws F
attaching the rear panel.
3.4 Removing the component board and tuner unit
(See Figs.5 and 6)
• Prior to performing the following procedure, remove the top
cover.
(1) From the top side of the main body, disconnect the parallel
wire from the connector
Fig.5)
(2) From the back side of the main body, remove the four
screws G attaching the component board. (See Fig.6)
(3) From the top side of the main body, disconnect the card
wire from the connector
(4) From the back side of the main body, remove the two
screws H attaching the tuner unit. (See Fig.6)
1-6 (No.MB167)
CN511 on the S-Video board. (See
CN1 on the tuner unit. (See Fig.5)
E
E
F
Rear panel
Fig.4
CN511
S-Video board Parallel wire
Tuner
Fig.5
H
Fig.6
E
Strain relief
F E F
CN1
Component board
G