Step 2 - Installation Of The Easyscan 2 Software - Nanosurf easyScan 2 AFM Operating Instructions Manual

I S
NSTALLING THE OFTWARE
Video Module version 2:
- Select 'No not this time'
- Click 'Next'.
- Select 'Install the software automatically (Recommended)'
- Click 'Next'.
The message 'Installed USB 2.0 A/V Converter is now displayed
- Click the 'Finish' button.
After the installation of the Drivers has finished, a step 1A may follow, that
completes the installation of the Video Module version 2.
- Click the 'OK' button.
When the installation of the Video Module version 2 is completed, the
computer must reboot. After rebooting, windows shows the notifications:
• Found New Hardware USB Device
• Found New Hardware USB EMP Audio Device
• Your New Hardware is now ready to use.
- Wait until the 'ready to use' message is displayed
The drivers 'USB Compound device', 'USB 2.0 A/V Converter' and 'USB
EMP Audio device' are now installed.
- Start the Setup program again (by double-clicking the installation CD in
windows Explorer)
- Click the 'Full Installation of Nanosurf easyScan 2' button.
The installation procedure should now continue with STEP 2. If the instal-
lation procedure does not continue, perhaps you have not waited for the
message 'ready to use', or something else went wrong during the installation
of the drivers for the video module.

Step 2 - Installation of the easyScan 2 software

- Click the default choice in all dialogs.
33