Table of Contents
Advertisement
With the checking of VR, JOG dials and switches, operating a control causes information to be displayed on the LCD. The LCD
display is retained until other information is displayed on the LCD. However, pressing the CALL button displays the initial display.
Check Point
IRIS
IRIS
MASTER
M.BLACK (SC FINE)
VR
BLACK
WHITE Bch(C)
WHITE Bch
WHITE Rch(Y)
WHITE Rch
SHUT JOG(LENGTH)
SHUTTER JOG
JOG
V.GAIN JOG(SC)
V.GAIN JOG
W.BAL(ASPECT)
W.BAL
SW
GAIN(VOLT)
STEP GAIN
DIP
DIP SW12345678
SW 1 to 8
SW
1.3.4 Adjustment Mode
The Adjustment mode is detailed in the description of the adjustment procedures. Please see section 2.2.
LCD Display
Turn this VR and confirm that data varies between 0 and 255.
Turning clockwise should increase the value.
This VR also controls the LCD contrast. It is Normal at the
128
center. Turning the VR clockwise should increase contrast
and counter-clockwise should decrease it. The LCD back light
should be OFF at the most clockwise position.
Turn this VR and confirm that data varies between 0 and 255.
Turning it clockwise should increase the value.
128
This VR also controls the SC FINE data output.
Turn this VR and confirm that data varies between 0 and 255.
Turning it clockwise should increase the value.
128
This VR also controls the LENGTH HF data output
Turn this VR and confirm that data varies between 0 and 255.
Turning it clockwise should increase the value.
128
This VR also controls the LENGTH Y data output
Turn this JOG and confirm that data is switched to 5M, 20M,
50M and 100M. Turning it clockwise should increase the
value.
20M
The initial value when the unit is turned ON is 20M.
This JOG also checks the JOG rotation and JOG hardware
when LENGTH is selected in addition to SHUTTER JOG
check.
Turn JOG and confirm that data is switched to 0°, 90°, 180°
and 270°. Turning clockwise should increase the value.
The initial value when the unit is turned ON is 0°.
0°
This JOG also checks the JOG rotation and JOG hardware
when SC COARSE is selected in addition to V.GAIN JOG
check.
Operate this SW and confirm that A, B and PRE are displayed
correctly when the SW is in the corresponding position.
This SW should also vary ASPECT internally: When A (16:9),
PRE(4:3)
B (Letter Box) and PRE (4:3) are displayed, the internal mode
should vary accordingly.
Operate this SW and confirm that LOW, MID and HIGH are
displayed correctly when the SW is in the corresponding
position.
LOW(15V)
This SW should also vary the supply voltage to the camera
internally: When LOW (15 V), MID (17 V) and HIGH (19 V) are
displayed, the internal voltage should vary accordingly.
Set each SW to ON and OFF and confirm that the
corresponding display changes to H (ON) or L (OFF).
LLLLLLLLL
Check Details
Remark
When the unit is
turned ON, 15 V is
output regardless
of the position of
this SW, until this
SW is changed to
another position.
1-5
Advertisement
Table of Contents
