Setup Procedure; Setup Using A Web Browser - Planet WAP-4060PE User Manual

IP address
MAC Address
IEEE Standard
FW Version
Description
Note: If the desired device is not listed, check that the device is installed and powered on, then
update the list by clicking the Refresh button.
Buttons
Refresh
Detail Info
Web Management
Set IP Address
Exit

3.2.2 Setup Procedure

1. Select the desired Wireless Access Point from the list.
2. Click the Set IP Address button.
3. If prompted, enter the user name and password. The default values are "admin" for the
User Name, and "password" for the Password.
4. Ensure the IP address, Network Mask, and Gateway settings are correct for your LAN.
Save any changes.
5. The initial IP address setup is now completed. You can click on the "Web Manage-
ment" button to access the web interface of WAP-4060PE for more configurations.

3.3 Setup using a Web Browser

Your Browser must support JavaScript. The configuration program has been tested on the
following browsers:
·
Netscape V4.08 or later
·
Internet Explorer V4 or later
3.3.1 Setup Procedure
Before proceeding, please install the WAP-4060PE in your LAN, as described previ-
ously.
1. Use a PC which is already connected to your LAN, and start the Web browser.
2. In the Address box, enter the IP address of the WAP-4060PE you want to cobnfig-
ure.
You should then see a login prompt, which will ask for a User Name and Password.
3.
Enter admin for the User Name, and password for the Password.
The IP address for the WAP-4060PE.
The hardware or physical address of the WAP-4060PE.
The wireless standard or standards used by the WAP-4060PE (e.g.
802.11b, 802.11g)
The current Firmware version installed in the WAP-4060PE.
Any extra information for the WAP-4060PE, entered by the administrator.
Click this button to update the Wireless Access Point device listing
after changing the name or IP Address.
When clicked, additional information about the selected device will
be displayed.
Use this button to connect to the WAP-4060PE 's Web-based
management interface.
Click this button if you want to change the IP Address of the Wire-
less Access Point.
Exit the Management utility program by clicking this button.
8