Wireless Network Connections; When Connecting The Device To The Network, The Following Procedures Must Be Followed; Power Up The Device - bioscrypt V-Flex 4G Installation Manual

Installation Guide – October 2009 – Edit Purposes Only

When connecting the device to the network, the following procedures must be followed:

After all devices are configured and connected to the RS-485 network, the baud rate
can be increased to the highest supported rate (some experimentation might be
required).

4.1.6.3 WIRELESS NETWORK CONNECTIONS

After the physical installation, the device can be configured for wireless network
connection. The wireless network can be set up either through SecureAdmin (see
Chapter 7 in the Operator's Manual) or through the front panel of the V-Station 4G
device.
To set up wireless operation through the front panel of a V-Station 4G device, perform
the following steps:

2. Power up the device.

Ensure that the wireless network is functioning.
Use one of these supported modes:
October 15 2009 – Installation Guide Draft – Edit Purposes Only
Use Category 5 cabling with a characteristic impedance of 120 ohms
for RS-485 networks. Category 5 cables with a characteristic
impedance of 100 ohms can also be used, but with lower performance.
Cable manufacturers provide cables with multiple twisted pairs
designed for this type of communication (characteristic impedance is
120 ohm).
Unused pairs within the cable must be terminated with characteristic
impedance (100 or 120 ohm) on both ends.
AWG 24 should be considered as the minimum gauge.
Choose one twisted pair of conductors to use for RS-485 differential
connections, other conductors should be used for Signal Ground (RS-
485 GND on Weidmuller connection).
The RS-232 to RS-485 converter must support Sense Data to be able
to switch from Send to Receive mode.
Check each device's cabling for ground faults before connecting to an
RS-485 network.
Each device should have pin 3 of the mini-connector connected to
earth ground.
WEP Open
WPA Personal
2009
Page 53