Advertisement
B. Wiring the K-1770-3 Phone
* Note: When installing a line powered phone on a low
voltage and/or low loop current phone system extension, a
TBB-1B Talk Battery Booster may be required (DOD# 632).
*** Note: To increase surge protection, loosen the PCB
mounting screw labeled
with spade terminal (included) from the mounting screw to
Earth Ground (grounding rod, water pipe, etc.)
To Optional Viking Entry Controllers (not included)
Model
DOD#
C-500
177
C-2000B
156
C-3000
162
C-4000
164
K-1900-3
312
** Note: The gel-filled (water-tight) butt connectors are designed for insulation displacement on 19-26 gauge
wire with a maximum insulation of 0.082 inches. Cut off stripped wire ends prior to terminating.
C. Wiring the K-1770-3 Proximity Card Reader
IMPORTANT: Electronic devices are susceptible to lightning and power station electrical surges from
both the AC outlet and the telephone line. It is recommended that a surge protector be installed to protect
against such surges.
3-Wire Gel-Filled Butt Connectors
included (3M Scotchlok UR2)
(shown right) and fasten a wire
Description
Advanced 2 Door Controller (see page 5)
Advanced 4 Door/Gate Controller (see page 6)
Multi-Tenant Entry System (see page 7)
Apartment/Office Entry Controller (page 7)
Apartment Entry Dialer (see page 6)
J1
White (Data 1)
White
Green (Date 0)
Green
- Black (GND)
Black
+ Red (5-14VD)
Red
Remote Touch Tone
Programming Phone
Back View of
the K-1770-3
12V DC
Adapter
(included
Share power with
with ES-1)
12-24V AC/DC door
strike with 200mA
available current or use
the included 12V DC
adapter.
Doorstrike
Power Supply
12-24V AC or DC
Doorstrike
24 Awg Stranded
Shielded Cable
(Belden 9537)
* Up to 500 ft
RAD-1A Remote Access
(not included)
Device (not included,
see DOD# 410)
3
6.5"
5.12"
J1
Red
Green
(Ring)
(Tip)
** Gel-Filled
Connectors
(included)
OR
Viking Model ES-1 (not included,
see DOD# 193 for more information)
VIKING
OR
Black
Red
Green
White
OR
Programming Phone
5.5"
4.04"
Spade
Terminal
(included)
*** Earth
Ground
(optional)
Rear View of
the K-1700-3
* C.O. Line or Analog
PABX/KSU Station
MODEL ES-1
©
VIKING
ELECTRONICS
HUDSON, WI 54016
STAND ALONE
DOOR CONTROLLER
ENTRY SYSTEM
1
2 3 4 5 6 7
8 9 10 11
To Viking model
ES-1 (shown)
or
C-4000 (page 7)
or equivalent 26-Bit
Wiegand Card
Reader Controller
Touch Tone
(not included)
Advertisement
