JVC MX-DK1US Service Manual page 10

3.1.3 Removing the front panel assembly
(See Fig.4 to 7)
(1) Disconnect the connector wires from connector
the transformer board. (See Fig.4)
(2) Disconnect the card wires from connector CN303,
and CN307 of the main board. (See Fig.5)
(3) Disconnect the connector wire from connector
the amplifier board. (See Fig.6)
(4) Remove the two screws D attaching the front panel assem-
bly from bottom side of main body. (See Fig.7)
(5) Remove the one screw E attaching the front panel assem-
bly from left side of main body. (See Fig.4)
(6) Remove the one screw F attaching the front panel assem-
bly from right side of main body. (See Fig.5)
(7) Remove the one screw G attaching the earth wire from
switch board to main board. (See Fig.5)
(8) Disengage the hook a and hook b of the both side of the
front panel and then take out the front panel assembly.
(See Fig.4, 5)
3.1.4 Removing the center chassis
(See Fig.1, 5)
(1) Disconnect the connector wire from connector
the main board. (See Fig. 5)
(2) Remove the one screw H attaching the center chassis.
(See Fig. 5)
(3) Remove the two screws J attaching the center chassis.
(See Fig. 1)
3.1.5 Removing the tuner pack
(See Fig.1, 5)
(1) Disconnect the card wire from connector
main board. (See Fig. 5)
(2) Remove the two screws K attaching the tuner pack. (See
Fig.1)
CN103
c
1-10 (No.MB515)
CN103
CN306
CN140
CN330
CN335
E
a
Fig.4
of
H
of
F
of
CN307
b
of the
CN306
CN335
CN330
CN312
CN313
CN314
CN303 CN309
G
CN311
Fig.5
CN140
Fig.6
Fig.7
d
D