Attaching The Toys; Care And Maintenance - Evenflo BOUNCE & LEARN Instructions Manual

Attaching the Toys

To install stalk toys, press firmly into tray as shown.
Pull up on stalk toys to make sure they are locked
in place.
To remove stalk toys, squeeze tabs K and lift stalk
toys from tray.
K
CLICK!
Remove
Attach toys by inserting straight edge into opening
and rotating down, as shown. Press firmly into tray
until you hear an audible click.
Batteries
Refer to battery door
for quantity and size of
batteries.
4
For Plastic Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water. Allow to air dry.
For Seat Pad:
Machine Wash Separately, Cold Water – Delicate Cycle. NO CHLORINE BLEACH.
Tumble Dry: 10 – 15 Minutes on Low Heat – Remove Immediately.
If musical toys fail to operate, check the batteries. Note: ONLY the batteries are replaceable. Dispose of old batteries safely.
DO NOT use this product if any parts are missing, damaged or broken.
BATTERY INFORMATION:
CLICK!
Battery life varies with use.
BATTERY SAFETY INFORMATION: Batteries are small objects. Batteries must be replaced by adults. Follow the polarity (+/-)
diagram in the battery compartment.
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Only batteries of the same or equivalent type, as recommended, are to be used.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• The supply terminals are not to be short-circuited.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Promptly remove exhausted batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• DO NOT allow unit to get wet.
• Dispose of used batteries properly.
Battery Replacement: To replace batteries, loosen screw and remove battery door. Discard old batteries properly and replace
with alkaline batteries. Replace door and tighten screw.
Troubleshooting:
Toy does not turn on or does not respond.
• Make sure batteries are installed correctly.
• Make sure battery cover is correctly secured.
• Install new batteries.
Toy makes improper responses.
• Check or install new batteries.
• Power Off then Power On, to reset.

Care and Maintenance

WARNING
5