Attaching The Toys; Assembling The Art Table - Stage 2 - Evenflo ExerSaucer Instructions Manual

Attaching the Toys

WARNING
Toys with cap MUST be in place
when Stage 1 is in use.
J > @
J > !
A > !
J > %
To remove batteries from mirror toy,
remove two screws J > % , and lift mirror face.
To replace mirror face, replace screws.
DO NOT OVERTIGHTEN.
To place toy with cap on ExerSaucer, set
toy cap J > ! on top of Leg, as shown. Push
down until tab rests in dimple
J > @
Leg to ensure toy is attached properly.
To remove toy from ExerSaucer, grab cap
and pull straight up.
J > #
J > $
WARNING
Secure Spin-Loc™ toys every time the
ExerSaucer is used.
To secure Spin-Loc toys on ExerSaucer
Tray, set toys on Tray and twist toy base
clockwise as shown. Pull up on toys to make
sure they are locked in place.
To remove Spin-Loc toys from Tray, twist toy
base counterclockwise, squeeze tabs
lift, as shown.
If Spin-Loc toy does not stay attached, clean
suction cup per cleaning instructions for
plastic parts on page 9.
Batteries
Refer to battery door
for quantity and size
of batteries.
Remove screw from battery door.
Replace screw after batteries have
J > ^
been replaced. DO NOT OVERTIGHTEN.
6
STAGE 2
on
A > !
Stage 2 is for use by children who can walk unassisted
Stage 2 Art Table MUST be in highest position at all times.
H
J > # ,
J > $ and
J > ^
Assembling the Art Table
WARNING
up to approximately 48 months.
Note: Remove all toys from ExerSaucer
before assembling the Art Table.
H
1. Remove Base
H
ExerSaucer.
2. Turn ExerSaucer upside down.
3. Remove Bounce Ring
D > !
Push tab D > @ until it releases from Tray.
Repeat until all six tabs are released
D > @
from Tray.
7
STAGE 2
from bottom of
D > ! from Tray.