Warnings; Assembling The Exersaucer - Evenflo BOUNCE & LEARN Instructions Manual

Assembling the ExerSaucer®
A > ! A > ! C
2. Place a spring C onto an upper pylon/leg assembly
Install a spring dome over the spring by hooking it into the upper pylon and clicking together, as shown, to create the
D C
upper leg assembly A > @ .
Repeat for the other two leg assemblies.
A > @
A > @ A > @
A > #
A > @
G
D
CLICK!
A > ! .
3. Place three upper leg assemblies
A > @
Attach each upper leg to the tray with four screws
Tighten screws securely, but do not overtighten.
E
F
4. Align and start each upper leg into the base leg
A > @
Push button A > # and guide upper leg into base leg until
upper leg clicks into place.
To adjust height:
ALWAYS remove baby from ExerSaucer® before adjusting.
Push adjustment button A > # until the desired position is
obtained. Make sure that all three legs are adjusted to the
same position.
WARNING
Allow only the baby's toes to touch the floor. DO NOT allow
the baby to stand flat-footed on the floor.
As baby grows and becomes more active, raise the tray to the
next level so that baby enjoys the most comfortable fit and
maximum use of the spin and bounce features. Discontinue
use when baby can stand flat-footed at the highest setting.
2
I
A > @
J
onto the tray .
E
F . I
F
CLICK!
.
G
H
CLICK!
I > !
J > !
J > @
I > #
I > @
7. Press assembled seat ring
tray
E
I > $
E
3
Assembling the ExerSaucer®
5. Place seat ring I upside down and
locate the wheel holders .
I > !
Click six (6) seat wheels H into wheel
holders, as shown.
6. Turn seat ring
I right side up. Align
triangle I > @ on the back of the seat
J > !
ring with the triangle on the seat
pad label. Snap the plastic tabs J > @
on the pad over the pegs I > # on the
seat ring. Continue this process until
all tabs are attached to all pegs.
I > $ down firmly onto the top of the
until it clicks into place and spins freely.