Care And Maintenance - Evenflo ExerSaucer Instructions Manual

Assembling the Art Table
H
H
4. Turn the ExerSaucer right-side-up.
5. Place Base in opening on
H
ExerSaucer Tray, as shown.
6. Base Cap can be placed in Tray
I
with rim facing up, as shown, to create
storage area for supplies.
8
For Plastic Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water.
DO NOT use abrasive cleaners or solvents. Allow to air dry.
For Wood Parts:
Wipe surface clean with cloth slightly moistened with mild soap and water.
DO NOT use abrasive cleaners or solvents. Immediately wipe dry with clean cloth.
For Seat Pad:
Machine Wash Separately, Cold Water – Delicate Cycle. NO CHLORINE BLEACH.
Tumble Dry: 10 – 15 Minutes on Low Heat – Remove Immediately.
If musical toys fail to operate, check the batteries. Note: ONLY the batteries are
replaceable. Dispose of old batteries safely.
DO NOT use this product if any parts are missing, damaged or broken.
BATTERY INFORMATION:
Battery life varies with use.
BATTERY SAFETY INFORMATION: Batteries are small objects. Batteries must be
replaced by adults. Follow the polarity (+/-) diagram in the battery compartment.
WARNING
• DO NOT mix old and new batteries.
• DO NOT mix alkaline, standard (carbon-zinc), or rechargeable (nickel-
cadmium) batteries.
• Only batteries of the same or equivalent type, as recommended, are to be
used.
• DO NOT dispose of batteries in fire, as batteries may explode or leak.
• The supply terminals are not to be short-circuited.
• DO NOT use rechargeable batteries.
• DO NOT recharge non-rechargeable batteries.
• Promptly remove exhausted batteries from the toy.
• Remove batteries before storing unit for a prolonged period of time.
• DO NOT allow unit to get wet.
• Dispose of used batteries properly.
Battery Replacement: To replace batteries, loosen screw and remove battery door.
Discard old batteries properly and replace with alkaline batteries. Replace door and
tighten screw.
Troubleshooting:
Toy does not turn on or does not respond.
• Make sure batteries are installed correctly.
• Make sure battery cover is correctly secured.
• Install new batteries.
Toy makes improper responses.
• Check or install new batteries.
• Power Off then Power On, to reset.

Care and Maintenance

9