Searching; Seek Search; Search Banks - Radio Shack 20-164 User Manual

Setup
To clone the scanner data:
1. Turn on both scanners.
2. Connect the connecting cable to each
scanner's PC/IF jack.
appears.
3. Press . "Confirm to send data?"
appears.
4. Press 1 to send the data to the other unit
or press any other key to cancel.
5. To exit the clone mode, remove the cable.
Note: "CLONE MODE Incorrect
Model" appears if you connect a scanner
other than a PRO-164 or PRO-163.
** CLONE MODE **
22

Searching

You can search for transmissions using the
preprogrammed search bank, which is divided
into eight search bands.

Seek Search

When Seek Search is active, the scanner stops
on active frequencies for five seconds and
then resumes searching automatically.
To activate Seek Search:
1. Press FUNC then 7.
appears briefly and
display.
2. To turn off Seek Search, press FUNC then
7 again. "Seek Search OFF"
briefly.

Search Banks

To search preprogrammed search banks:
1. Press SRCH repeatedly to select a bank.
Bank Band
SR0 Marine
SR1 CB
SR2 FRS/GMRS/MURS
SR3 Public Safety
SR4 Aircraft
SR5 Amateur Bands
SR6 Railroad
SR7 Limit search (User change-
able)
23
Searching
"Seek Search ON"
S
appears on the
appears
Freq. Chart
Page 61
Page 62
Page 62
Page 63
Page 65
Page 65
Page 65