JVC RX-D201S Service Manual page 8

3.1.2 Removing the front panel assembly
(See Figs.3 and 4)
• Remove the top cover.
(1) From the top side of the main body, remove the tie bands
bundling the wires. (See Fig.3.)
Reference:
After reassembling, bundle the wires with the new tie
bands as before. (See Fig.3.)
(2) Disconnect the card wire from the connector
main amplifier board. (See Fig.3)
(3) Disconnect the wire from the connector
amplifier board. (See Fig.3)
(4) Disconnect the wire from the connector
board. (See Fig.3)
(5) Disconnect the wire from the connector
board. (See Fig.3)
(6) Remove the three screws C attaching the front panel as-
sembly. (See Fig.3)
(7) Remove the screw D attaching the OSD connect 2 board.
(See Fig.3)
(8) From the bottom side of the main body, remove the four
screws E attaching the front panel assembly. (See Fig.4)
(9) Release the joints a and remove the front panel assembly
in the direction of the arrow. (See Fig.4)
1-8 (No.MB364)
CN102 on the
CN351 on the main
C
CN552 on the input
CN661 on the DSP
CN552
Front panel assembly
OSD connect 2 board
CN102
C
CN661
Input board
DSP board
Fig.3
Front panel assembly
E
a
Fig.4
Main amplifier board
D C
CN351
Tie bands
E