JVC RX-D201S Service Manual page 15

3.1.20 Removing the master clock board
(See Fig.16)
• Remove the top cover, tuner, DSP board, PWM modulation 1
board, PWM modulation 2 board and OSD connect 1 board.
(1) Remove the two screws U with a short driver and remove
the transistor hold from the joints n of the heat sink.
(2) Disconnect the wire from the connector
amplifier board.
(3) Take out the master clock board from the main body.
CN201 on the main
Heat sink
Transistor hold
n
U
CN201
Main amplifier board
Fig.16
n
Master clock board
(No.MB364)1-15