Trouble Shooting - Dell E153FPc Service Manual

9.2 Trouble shooting

9.2.1 Main Board
No Display
Measured CN104 pin5 = 5 V?
Measured U101 pin 44= 5V?
Measured U105 pin 2= 3.3V?
Disconnected the Signal cable (Loose the
Signal cable), Is the screen show Block
WRGB color bars?
Connected the Signal
cable again Check LED
status.
Check the Wire-Harness from CN101
Check Panel-Power Circuit Block
Check U200 Data-output Block
Replace Inverter board and Check
Inverter control relative circuit
Re-do White balance adjust
Note: 1. If replace "Main-Board", Please re-do "DDC-content" programmed & "White-Balance".
2. If replace "Power Board" only, Please re-do " White-Balance"
Downloaded from www.Manualslib.com
www.ma163.com 电子技术资料网
OK
NG
Orange
OK, Keyboard no stuck
Green
OK, Wire tight
enough
OK, Panel Power OK
OK, U102 data OK
manuals search engine
Check Power board, is there DC level output?
NG
Check U105 pin3=5V, U105 pin2=3.3V?
Is there any shortage or cold solder?
OK
Connected the Signal cable again,
Check LED status.
Check Power switch is in Power-on
status, and check if Power switch had
been stuck?
Measured RGB (R112, R114,)
H/V Input at U102 pin 95,96,
Was there have signal?
OK
Measured Crystal X101
OK
Replace U102 (ZAN3XL)
OK
36
Dell E153FPc
Green
ReplaceU102
Scalar IC
Orange
Check
Correspondent
component
short/open
(Protection Diode)
NG