Table of Contents
Advertisement
ICD-P330F
1. Outline of the TEST MODE
The TEST MODE is designed to help verify the set when servicing
it.
The TEST MODE is only menu driven to select modes for servicing.
2. Entering and Canceling the TEST MODE
With the power on, turn on the [HOLD] switch while pressing the
button and the
•
x STOP
DISPLAY/MENU
3. Canceling the TEST MODE
The TEST MODE can be cancelled by turning off the power
(unplugging the dry battery).
4. Menu Key Designation
The menu has the five modes described below. The following keys
are assigned on the initial screen (version display).
5. Key Assignment
From within TEST MODE, the intended menu can be entered by
using the appropriate one key of the following key.
LCD Test (All Ony All Off)
BEEP Test (1.3 kHz)
HQ-DSP LOOP
SP-DSP LOOP
LP-DSP LOOP
USB Test
REST MENU Test
Initial Display from each mode
5-1. Initial Display in TEST MODE
LCD indications (destination information, memory capacity, CPU
FW information and MIC sens) when TEST MODE is entered:
MIC sens
H
Destination
information
5-2. LCD Test
To enter the LCD Test, press the
Test has two modes: All On and All Off First all the indicators are
on. All the indicators are off when the button is pressed again.
ALL ON
A B C D
LP
SPHQ
H
L
•
DISPLAY/MENU
REQ
FM
Switch between
EASY-S
REC
DATE
the modes.
REMAIN
LOCAL YH
MM MHz DS
Press the
button to return to the initial display (destination
x STOP
information, memory capacity, CPU FW information and MIC sens).
6
SECTION 3
TEST MODE
button at the same time.
•
DISPLAY/MENU
FM•i/5
zX REC/PAUSE
– .
> +
Nx PLAY/STOP(ENTER)
DIVIDE
x STOP
Memory capacity
(128-128 MB)
(64-64 MB)
(32-32 MB)
(16-16 MB)
CPU FW information
button. The LCD
•
DISPLAY/MENU
ALL OFF
5-3. BEEP Test
To enter the BEEP Test, press the
Beep: Frequency 1.3 kHz only
Press the
button to return to the initial screen (memory and
x STOP
CPU version).
5-4. DSP LOOP
The DSP LOOP modes can be entered selectively by pressing the
appropriate one of the following three keys.
Within the LOOP test menu, "LOOP" is displayed. The sensitivity
character H or L is displayed depending on the position into which
the [HOLD] switch is placed.
The sensitivity H is displayed when [HOLD] switch is in the ON
position. The sensitivity L is displayed when [HOLD] switch is in
the OFF position.
zX REC/PAUSE
H
.
H
>
H
To change the DSP LOOP test mode, press the
select the
button,
zX REC/PAUSE
In a DSP Test mode, to select another DSP Test mode and to select
the other sensitivity, the
x STOP
button.
FM • i/5
HQ
SP
LP
button, then
x STOP
–
button, or
+
button.
.
>
button also has to be pressed.
Advertisement
Table of Contents
