Sony ICD-P17 Service Manual
Hide thumbs Also See for ICD-P17:

Advertisement

SERVICE MANUAL
Ver 1.1 2003. 12
Sony Corporation
9-877-245-02
2003L04-1
Personal Audio Company
© 2003. 12
Published by Sony Engineering Corporation
SPECIFICATIONS
Recording media
Built-in flash memory, Monaural recording
Recording time
278 minutes
Frequency response
150 Hz - 3,500 Hz
Speaker
approx. 3.2 cm (1
Power output
250 mW
Input/Output
• Earphone jack (minijack) for 8 - 300 ohms
earphone/headphones
• Microphone jack (minijack, monaural)
Plug in power
Minimum input level 0.6 mV
3 kilohms or lower impedance microphone
Power requirements
Two LR03 (size AAA) alkaline batteries: 3 V DC
Dimensions (w/h/d) (not incl. projecting parts and controls)
44.5 × 105.3 × 14.0 mm (1
Mass (incl. batteries)
71 g (2.5 oz)
Supplied accessories
USB connecting cable (1)
Application software (CD-ROM) (1)
Design and specifications are subject to change without notice.
ICD-P17
Canadian Model
in.) dia.
5/16
× 4
×
in.)
13/16
1/4
9/16
US Model
AEP Model
UK Model
Tourist Model
IC RECORDER
1

Advertisement

Table of Contents
loading

Summary of Contents for Sony ICD-P17

  • Page 1 71 g (2.5 oz) Supplied accessories USB connecting cable (1) Application software (CD-ROM) (1) Design and specifications are subject to change without notice. IC RECORDER Sony Corporation 9-877-245-02 2003L04-1 Personal Audio Company © 2003. 12 Published by Sony Engineering Corporation...
  • Page 2: Table Of Contents

    ICD-P17 Notes on Chip Component Replacement TABLE OF CONTENTS • Never reuse a disconnected chip component. • Notice that the minus side of a tantalum capacitor may be dam- 1. SERVICE NOTE ..............3 aged by heat. 2. GENERAL •...
  • Page 3: Service Note

    ICD-P17 SECTION 1 SERVICE NOTE 1-1. CAUTIONS OF FLASH MEMORY (IC701) EXCHANGE [Precaution when the flash memory (IC701) is replaced] When the flash memory (IC701) is replaced, be sure to perform the BAD BLOCK check* and writing of the model code. If they are not completed, the unit will not operate normally.
  • Page 4: General

    ICD-P17 SECTION 2 GENERAL This section is extracted from instruction manual.
  • Page 5: Disassembly

    ICD-P17 SECTION 3 DISASSEMBLY Note : This set can be disassemble according to the following sequence. 3-1. UPPER LID BLOCK ASSY (Page 5) 3-2. F-SW BOARD, P-SW BOARD (Page 6) 3-3. MAIN BOARD (Page 6) 3-4. PC BOARD (Page 7) Note : Follow the disassembly procedure in the numerical order given.
  • Page 6: F-Sw Board, P-Sw Board

    ICD-P17 3-2. F-SW BOARD, P-SW BOARD 5 P-SW board 4 F-SW board 3 Removal the seven solders. 1 Removal the solder. case block assy 2 CN703 3-3. MAIN BOARD 3 screw (1.7x3.0) 2 speaker (SP101) 6 CN801 1 Removal the two solders.
  • Page 7: Pc Board

    ICD-P17 3-4. PC BOARD 1 screw (1.7x3.7) 3 holder (jack) 2 PC board case (lower) assy...
  • Page 8: Test Mode

    ICD-P17 SECTION 4 TEST MODE [Setting Method of the Test Mode] [Operation in the Test Mode] (1) To enter the test mode, turn on the HOLD switch while After entering the test mode, you can move within the test menu by pressing the .
  • Page 9 ICD-P17 3. Sleep test 6. Key entry test • Pressing the x•B key causes the set to enter the sleep state. • When the any key is pressed, the entry key and the A/D • Press any keys to exit the sleep state.
  • Page 10 ICD-P17 9. USB test 11. Menu reset • Pressing the x•B key causes the set to enter the menu • When the menu starts the USB self-check, either presence or absence of the Vbus is judged. initialization standby state. (Vbus is present: “VBUS: ON”, Vbus is absent: “VBUS: OFF”) •...
  • Page 11: Diagrams

    ICD-P17 SECTION 5 DIAGRAMS 5-1. IC PIN DESCRIPTION • IC702 MB91F233-148 (SYSTEM CONTROL) (MAIN BOARD) Pin No. Pin Name Pin Description DSPSCK Serial clock signal output to the DSP IC (IC101) FLMCLE Command latch enable signal output to the flash memory IC (IC701) 3 –...
  • Page 12 ICD-P17 Pin No. Pin Name Pin Description DSPIFACK DSP I/F acknowledge signal input DVCC — Power supply pin DVSS — Ground pin XTALIN Main oscillator input pin XTAL Main oscillator output pin XINTUSB Interruption request signal input from the USB driver IC (IC8101)
  • Page 13: Block Diagram

    ICD-P17 5-2. BLOCK DIAGRAM A/D,D/A CONVERTER,DSP IC101 MIC101 POWER AMP RV101 IC110 LOUT0 SP101 –IN (SPEAKER) J101 J102 MUTE SHUTDOWN SYSTEM CONTROL,LCD CONTROL Q101 PLUG IN IC702 POWER FLASH MEMORY IC701 BEEP XOUT AMPPWR LMUTE X101 4.096MHz SHDO EGPIO11 DSPSIN...
  • Page 14 ICD-P17 • Waveforms THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS. (In addition to this, the necessary note is printed in each block.) 1.0Vp-p Common Note on Schematic Diagrams: 4.096MHz • All capacitors are in µF unless otherwise noted. pF: µµF...
  • Page 15: Printed Wiring Board - Main Section

    ICD-P17 5-3. PRINTED WIRING BOARD — MAIN SECTION — • Refer to page 14 for Common Note on Printed Wiring Boards. : Uses unleaded solder. MAIN BOARD (SIDE B) • Semiconductor C117 TP503 TP720 R101 TP102 Q510 TP801 Location TP803 Q509 Ref.
  • Page 16: Printed Wiring Board - F-Sw Section

    ICD-P17 5-4. PRINTED WIRING BOARD — F-SW SECTION — • Refer to page 14 for Common Note on Printed Wiring Boards. : Uses unleaded solder. F-SW BOARD (SIDE A) MAIN BOARD CN704 CN703 (Page 15) TP707 TP706 TP710 TP708 R712...
  • Page 17: Printed Wiring Board - P-Sw, Pc Section

    ICD-P17 5-5. PRINTED WIRING BOARD — P-SW, PC SECTION — • Refer to page 14 for Common Note on Printed Wiring Boards. : Uses unleaded solder. P-SW BOARD (SIDE A) TP704 TP702 TP701 R703 TP703 R702 R704 R705 R701 1-688-460-...
  • Page 18: Schematic Diagram - Main Section (1/2)

    ICD-P17 • Refer to page 14 for Common Note on Schematic Diagrams and Waveforms. 5-6. SCHEMATIC DIAGRAM — MAIN SECTION (1/2) — • Refer to page 20 for IC Block Diagrams. X801 C803 C805 R808 C802 R813 R806 IC701 IC802...
  • Page 19: Schematic Diagram - Main Section (2/2)

    ICD-P17 • Refer to page 14 for Common Note on Schematic Diagrams and Waveform. 5-7. SCHEMATIC DIAGRAM — MAIN SECTION (2/2) — • Refer to page 20 for IC Block Diagram. TP716 R730 R731 R716 R717 CN801 CN802 CN803 FB801...
  • Page 20: Ic Block Diagrams

    ICD-P17 5-8. IC BLOCK DIAGRAMS IC110 LM4903MMX/NOPB IC502 XC9105D091MR (MAIN Board) (MAIN Board) VOUT VDD/2 AV=-1 XSHUTDOWN VREF WITH CURRENT BIAS SOFT START, RIPPLE DETECTION BYPASS CHIP ENABLE AND FB ERROR PWM/PFM CONTROLLER RAMP WAVE PHASE GENERATOR, COMPENSATION COMPARATOR BUFFER,...
  • Page 21: Exploded Views

    ICD-P17 SECTION 6 EXPLODED VIEWS NOTE: • The mechanical parts with no reference • Color Indication of Appearance Parts number in the exploded views are not supplied. Example : • Items marked “*” are not stocked since KNOB, BALANCE (WHITE) ... (RED) they are seldom required for routine service.
  • Page 22: Main Board Section

    ICD-P17 6-2. MAIN BOARD SECTION LCD901 MIC101 Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark * 51 A-3683-607-A MAIN BOARD, COMPLETE 3-250-352-01 HOLDER (LCD) * 52 A-3683-610-A P-SW BOARD, COMPLETE 3-254-966-01 SHEET (B) 3-250-362-01 TERMINAL (–), BATTERY...
  • Page 23: Electrical Parts List

    ICD-P17 SECTION 7 F-SW MAIN ELECTRICAL PARTS LIST NOTE: When indicating parts by reference • Due to standardization, replacements in • Items marked “*” are not stocked since number, please include the board. the parts list may be different from the they are seldom required for routine service.
  • Page 24 ICD-P17 MAIN Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark < CONNECTOR > < RESISTOR > CN703 1-816-624-21 CONNECTOR, BOARD TO BOARD 10P R101 1-218-961-11 RES-CHIP 4.7K 1/16W CN801 1-816-624-21 CONNECTOR, BOARD TO BOARD 10P R102...
  • Page 25 ICD-P17 Ver 1.1 MAIN P-SW Ref. No. Part No. Description Remark Ref. No. Part No. Description Remark R726 1-218-965-11 RES-CHIP 1/16W S704 1-771-053-21 SWITCH, KEYBOARD (B • x PLAY/STOP R727 1-218-965-11 RES-CHIP 1/16W (ENTER)) R729 1-218-990-11 SHORT CHIP S705 1-572-922-11 SWITCH, SLIDE (HOLD)
  • Page 26 ICD-P17 REVISION HISTORY Clicking the version allows you to jump to the revised page. Also, clicking the version at the upper on the revised page allows you to jump to the next revised page. Ver. Date Description of Revision 2003. 04 2003.

Table of Contents