Troubleshooting; Technical Specification - Akai AB-40K SCORPIO User Manual

If a fault occurs, first check the points listed below before taking the set for repair. If you are unable to
remedy a problem by following these hints, consult you dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate the
guarantee.
PROBLEM
No sound in general
The unit does reset to
operation of any button
Radio poor reception
CD cannot read
No sound in USB mode
Power Supply
Power consumption
Standby power consumption
Dimensions (H × W ×D)
Net Weight
Radio section
Frequency Coverage
USB section
Power Output
Speakers
IMPORTANT: Due to continual revision and improvement on our products design,
specifications are subject to change without further notice.
TROUBLE SHOOTING
POSSIBLE CAUSE
Volume not adjusted.
Mains supply is not correctly
connected.
Under the influence of
electrostatic phenomenon, the
product may malfunction and
require user to disconnect.
Weak radio aerial signal.
Interference caused by the
vicinity of electrical
equipment like TVs, video
recorders, computer,
thermostats, fluorescent
lamps (TL) engines etc.
The disc is dirty
The disc is upside down.
The CD player is in Pause
mode
Volume at minimum.
External device not connected
properly.

TECHNICAL SPECIFICATION

AC230V~50Hz
DC 12V (LR14-1.5VX8 –piles non fournies)
20 W
0.8 W
133mm x 323mm x 228mm
1.685 kg
FM: 87.5 – 108MHz - AM: 520- 1620 KHz
Support USB flash-drive up to 8 GB
2x 3.6 W (1.8 W RMS x 2)
4 Ohms 3inch x 2
22
REMEDY
Adjust the Volume knob.
Connect the mains supply
properly.
Turn off the unit, disconnect the
mains plug, and reconnect after
a few seconds.
Aim the aerial for best reception:
Fully extend the telescopic
antenna.
Keep the unit away from electrical
equipment.
Clean or replace the disc
Turn it over so that the label is
face up.
Release the Pause Mode by
pressing the Play/Pause button.
Adjust the volume knob.
Clear contact pins and connect
again.