Planar PX2611W User Manual page 13

Provide information about resolution, H/V frequencies,
Information
and polarity of the input signal.
This OSD informs the user the current signal that is
displayed.
Input Select
This OSD will automatically turn off after 2 seconds or by
pressing the "Exit" key.
This OSD gives a warning when the selected input signal
is not active. After power on or when the input signal
become inactive, this warning appears.
OSD Warnings
No signal OSD shall be shown after around 0.5sec from
NO SIGNAL video mode detection. This OSD shall be turned off after 5
seconds automatically, or by "EXIT" key. Then change to
power saving mode. If direction key is pressed during
power saving mode, this warning OSD is opened again.
This function gives warning about input resolution or
refresh rate that the monitor cannot display.
OSD Warnings
If video signal is not at the proper timing when the
OUT OF RANGE
monitor powers on or input signal is changed, this
message opens and it disappears after 45 seconds, or by
"EXIT" key.
11