Page 3
The information contained in this document is subject to change without notice. This document contains proprietary information that is protected by copyright. All rights are reserved. No part of this document may be reproduced, translated to another lan- guage or stored in a retrieval system, or transmitted by any means, electronic, mechanical, photocopying, recording, or otherwise, without prior written permission.
Usage Notice Precautions ... 2 Introduction About the Product ... 3 Package Overview ... 4 Installation Product Overview ... 5 Start Your Installation ... 8 User Controls Front Panel Controls ... 10 How to Use the OSD Menus ... 11 On-Screen Display Menus ...
Page 6
Warning- Warning- Turn off the product before cleaning. Use only a dry soft cloth or clean room wiper when cleaning the LCD Display screen surface. Use a soft cloth moistened with mild detergent to clean the display housing. Use only a high quality and safety approved AC/DC power adapter. Disconnect the power plug from the AC outlet if the product is not going to be used for an extended period of time.
About the Product Analog and Digital dual signal input Composite and S-Video signal input USB port connectivity 23.1” diagonal screen size 1920 x 1200 high resolution Wide Viewing Angle Technology 30 ~ 95 kHz horizontal scan 60 ~ 85 Hz refresh rate Auto Adjustment capability PIP (Picture-in-Picture) and PAP (Picture-and-picture) capability High quality full screen re-scaling capability...
Connecting the Display (Figure 10.1) Notice:To ensure the LCD Display will work well with your computer,please configure the display mode of your graphics card to make it less than or equal to 1920 x 1200 resolution and make sure the timing of the display mode is compatible with the LCD screen.
Front Panel Controls No/Icon ❶ MENU Menu button 1. Auto ❷ SELECT 2. Select 1. Brightness ❸ ▼ 2. Adjust 1. Mute ❹ ▲ 2. Adjust ❺ Power LED ❻ Power switch Control To Enter / Exit the OSD menus. 1.To activate the"Auto Adjustment"...
How to Use the OSD Menus 1. Press the “MENU” button to pop up the on-screen menu and to select among the six Main Menus. 2. Choose the adjustment items by pressing the “SELECT” button. 3. Adjust the value of the adjustment items by pressing the “ or “...
1. VGA / DVI Input Main Menu Menu Level 2 Menu Level 3 Volume Contrast Color PIP Mode Source Size H. Position V. Position Source Aspect Ratio Image Advanced H. Position V. Position Language Time-out H. Position V. Position Information Reset To adjust the sound volume.
2. Video Input Main Menu Menu Level 2 Menu Level 3 Volume Contrast Color PIP Mode Source Size H. Position V. Position Source Sharpness Image Aspect Ratio Noise Reduction Noise reduction is implemented noise reduction filters to the video data. Advanced H.
Troubleshooting If you are experiencing trouble with the LCD display, refer to the following trouble shooting. If the problem persists, please contact your local dealer or our service center. Problem: No image appears on screen. Check that all the I/O and power connectors are correctly and well connected as described in the “Installation”...
Warning Signal Sometimes you may see warning messages for this LCD Display. This means that the LCD Display cannot correctly receive the signal from the computer graphics card. No Input Signal This message means that the LCD Display has been powered on but it cannot receive any signal from the computer graphics card.
Compatibility Modes Mode IBM VGA IBM VGA VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA DMT VESA GTF VESA DMT VESA DMT VESA DMT VESA DMT VESA CVT VESA CVT VESA CVT VESA CVT VESA CVT...