Managing Your Z-Wave Devices; Adding Z-Wave Devices; Removing A Z-Wave Devices - Nokia G-240WZ-A User Manual

Once a device is paired (refer to the Pairing section below), it is automatically categorized as an
Unassigned or Unsupported device and is displayed on the Smart Home screen.
Unassigned Devices
Devices supported by the Nokia Smart Home Solution (See the Appendix - A for a list of supported
devices) are listed under this category and can be assigned to any one the created rooms.
Unknown Devices
Devices not recommended by Nokia Smart Home Solution will be listed under this category, Devices
may or may not work normally and cannot be assigned to any of the created rooms. They will be
automatically reflected under Unknown Room after pairing.
Clicking on any device will pop up a Device Information Screen providing its Name, Hardware Vendor,
Hardware Version and the Room where it is operating. You can edit the Name of a device, assign it
to a different room or delete/un-pair it
4.0

Managing your Z-Wave Devices:

4.1

Adding Z-Wave devices:

1. Device Operation Menu has 3 options - Add, Remove and Refresh Network.
2. To pair a Z-Wave device with the ONT, click on the Add device icon under the Device
Operations menu.
3. The ONT goes into the pairing mode and below screen will pop up.
4. Start the inclusion mode in the slave device (Refer individual device documentation, on how
to put the smart slave device into inclusion mode)
5. After successfully pairing the smart device a Done message will be displayed.
6. If the paired device is a preferred device, it will be shown under "All Devices" menu in
Overview Tab with correct icon type.
7. If the paired device is a non-preferred device, it will be shown under "All Devices" menu in
Overview Tab with correct icon type and with unsupported text inside icon.
8. If the paired device is an unknown device type, it will be shown under "Unknown" Rooms in
Rooms tab, with unknown icon type.
4.2

Removing a Z-Wave devices:

1. To un-pair a Z-Wave device from the ONT, click on the Remove icon in the device operations
menu.
2. The ONT goes into the unpairing mode. ONT will now wait for the device to be excluded.
3. Start the Exclusion mode of the slave device (Please refer the individual device
documentation on how to put the smart device into exclusion mode)
4. After successfully Unpairing the smart device a Done message will be displayed.
5. Device
rules/scenarios/schedules.
6. All preferred, non-preferred and unknown paired devices can be unpaired using the above
methods.
Nokia Smart Home 7368 GPON ONT - G-240WZ-A User Manual
.
is automatically removed from assigned Rooms
9
and automation