Planar LA1500R Operation Manual page 9

Connecting the display
To configure this monitor, please refer to the following figure and
procedures.
1. Be sure all equipment is off.
2. Connect the DC power cord to the power connector. Plug one end
of the AC power cord into the power adapter, and the other end into
an electrical outlet(1).
3. For the PC with Analog output: connect the VGA signal cable from
display VGA input connector to the 15-pin connector of your host
computer and tighten the screws(2).
4. Connect the USB cable from USB port of your display to the USB
port of your computer(3).
5. Turn on your computer, display and video source.
Notice: To ensure the LCD display works well with your computer, configure
the display mode of your graphic card to less than or equal to 1024 x
768 resolution and make sure timing of the display mode is compatible
with the LCD panel. "Compatibility Modes" of this LCD panel are
listed in the appendices for your reference.
(Figure 1.1)
9